End of Line Industrial Quality Testing
Defects? Misassembly? Interferences? No problem!
You are cordially invited to an educational seminar on end of line industrial quality testing at Siemens Digital Industry Software in Troy, MI on February 4, 2020.
You will learn:
- How to use noise and vibration to do quality inspection of rotating machinery products at end of line?
- What are the best sensors to use for end of line tests? How to do contact less measurements?
- How to integrate with end of line quality systems?
- What kind of issues can be detected in an end of line test? What type of metrics can be used?
- How can the acoustic signature of part determine if there are faults?
Practical demonstrations will be given throughout the day of the various concepts being covered.
Registrace je uzavřena
Omlouváme se, ale registrace na tuto akci je nyní uzavřena.
Agenda
zobrazit podrobný programCoffee and welcome
General layout of end of line quality inspection system
- Sensors
- Hardware
- Software
- Software interfaces to PLC, quality management systems
Considerations for sensors and hardware
Sensors considerations for industrial testing
- Bandwidth
- Reliability
- Resonances
Test bench considerations for noise and vibration testing
- Gearing of test bench versus gearing of test part
- Isolation of test bench and test part
- Repeatability of test benches-- multiple benches? Worldwide deployment?
Lunch provided
Software concepts for industrial tests
Innovative signal processing methods
- Order cepstrum
- Angle synchronous measurement and analysis
- Modulation and enveloped analysis
Adapting to new tasks
- Modular approaches
- Avoiding programming for quick setup
- Root cause
- Statistics
- Limit setting
Break
Examples of fault detection
- Misassembled parts
- Part interference
- Defective parts
- Transmissions
- Gear mesh issues
- Electric motors
- Internal combustion engines
- and more!
Close