Siemens PLM cordially invites you for an informative and educational day covering the process and best practices for predicting and optimizing rotating machinery dynamics in Cincinnati, OH on Thursday, May 3rd, 2018.
This seminar can help you answer questions like:
In this seminar, both simulation and test methods will be presented in an interactive, side-by-side format.
8 a.m. - Welcome and coffee
8:30 a.m. - Order Analysis and Tracking
-What is an order? How is it calculated?
-How are orders measured, simulated and interpreted?
-Review of orders generated by common equipment
9:30 a.m. - Torsional Vibration
-What is torsional vibration?
-How are torsional vibrations measured and analyzed?
-Resonances, drivelines, engines and other examples
-Lumped parameter models of torsional vibration
10 a.m. - Break
10:15 a.m. - Gears
-Gear transmission error
-Gear sideband orders: eccentric gears and offset rotation
11:30 a.m. - Lunch
12:30 p.m. - Bearings
-Bearing frequencies: inner race, outer race, fundamental train frequency
-Bearing faults and envelope analysis
1 p.m. - Pumps
-Hydraulic pump basics
1:30 p.m. - Electric Motors
-AC and DC motors
-Switching frequencies and PWM Controllers
2 p.m. - Break
2:15 p.m. - Balancing
-Imbalance: mass versus speed effects
-Shaft centerline plots
2:45 p.m. - Angle Domain Processing
-Angle versus time data
-Viewing data in degrees, revolutions or cycles
-Examples of angle domain analysis: piston slap, pilot ignition, etc.
3:15 p.m. - Resonances
-What is a resonances? How is it identified?
-Operational deflection shapes
-CAE and test correlation
4:30 p.m. - Close
Siemens PLM Software
2000 Eastman Dr
Milford, OH 45150